Module linéaire AGORA Technique

Axial joints for tractive forces adjustable Material: Steel. Version: Ball thrust pins galvanized and chromed. Ball seat and nuts galvanized. Note: Axial joint suitable for taking up tractive forces. The ball's movement can be controlled or fully locked in position using the clamping nut.

Material: Carriage die-cast zinc. Mounting plate aluminium. Bearing material iglidur® J. Version: Carriage chromed. Mounting plate anodized. Note: DryLin® W carriages are maintenance-free and corrosion resistant. Lacking the need of lubrication makes the system highly dirt resistant. Low friction coefficient in dry running and very quiet. Due to the flat and wide design, high torques are possible. Speeds up to 15 m/s. Applicable temperature -40 °C to +90 °C. Accessory: Double guide rails 21240.

Threadless ball screws The threadless ball screw is designed mainly for handling mechanisms of manipulators and transporting devices, which require effective transition of the rotary motion to linear without the preference of high rigidity and load capacity, but with the requirement for simplicity, easy maintenance and easy production. Screw thread is produced only in the nut and the transition of the load is provided only through the balls in the nut and the smooth cylindrical surface of the shaft. The principle is based on the elastic deformation of the surface of the hardened and ground shaft caused during the rolling of the preloaded balls guided in the inner screw thread of the nut. In this application it is possible to use the slippage of the nut on the shaft after exceeding certain axial force as a safety element. The nut continues in its motion in the original direction after the decrease of the load, or the current increase causes drive disconnection. Threadless ball screws : www.ks-kurim.cz/en/additional-assortment/threadless-ball-screws/